Sunday, September 21, 2014

LED Indicator Relay Timer Circuit 9 Second

This Relay Timer circuit provides a visual time 9 second delay using ten LED before control by closing a 12 VDC relay. That the reset switch has closed, IC 4017 decade counter will be reset to zero count which illuminates the LED driven from pin 3.


IC 555 timer output at pin 3 will be high and the voltage at pins 6 and 2 of the timer will be a little less than the lower trigger point, or about 3 Vdc.

That time the switch is opened, the transistor in parallel with the timing capacitor (22uF) is shut off allowing the capacitor to begin charging and the IC 555 timer circuit to produce an approximate one second clock signal to the decade counter. The counter advances on each positive going change at pin 14 and is enabled with pin 13 terminated low. When the 9th count is reached, pin 11 and 13 will be high, stopping the counter and energizing the relay. Longer delay times can be obtained with mostcapacitor or most resistor at pins 2 and 6 of the IC 555 timer

Source: 9 Sec Timer with LED indication and Control Relay Circuit
Categories: , , , , , ,

0 comments:

Post a Comment