Simple 100 watt Inverter Citcuit Using IC 4049

You should not install the transistors straight onto the heat sinks. Make use of mica isolation kit to prevent immediate exposure and short circuiting of the transistors together as well as the ground.

Clamp the heat sink set up to the of a nicely ventilated, durable, heavy gauge metal enclosure.
Additionally attach the power transformer beside the heat sinks employing nuts and bolts.
Now attach the suitable areas of the constructed circuit board to the power transistors on the heat sinks.
Lastly connect the power transistor’s outputs to the supplementary winding of the power transformer.
Complete the building by fixing and interconnecting the exterior electrical “fittings” such as fuses, sockets, buttons, mains cord along with the battery inputs.
An alternative individual power source circuit using a 12V/3Amp. transformer might be included inside to recharge the battery the moment needed (see diagram).




You may further discover how to construct a simple 100 watt inverter circuit by focusing on the following examination method:


To better know how to construct an inverter, you will need to find out how the circuit features by means of nthe following actions:
Gates N1 and N2 of IC 4049 are configured as an oscillator. It carries out the major operation of providing square waves to the inverter part.
Gates N3... N6 are utilized as buffers to ensure that the circuit is not load dependant.
Alternating voltage from the buffer phase is applied to the base of the current amplifier transistors T1 and T2. These particular transistors execute in line with the applied alternating voltage and amplifies it to the base of the output transistors T3 and T4.

All these output power transistors oscillate at a complete swing, dispensing the full battery voltage into the every half of the secondary winding alternately.

This secondary voltage is brought on in the main winding of the transformer which is stepped-up into an effective 230 volts (AC). This voltage is employed to power the output load.
Testing Procedure

You can further understand how to build an inverter by focusing on the following testing procedure given in a comprehensive manner below:



Start out the testing method by attaching a 1 hundred watt bulb at the output socket of the inverter,

Add a 15 Amp./12V fuse inside the fuse holder,

At last connect a 12V car or truck battery to the battery inputs of the inverter.

If all the contacts are proper, the 100 Watt bulb must right away light brightly.

Continue the inverter ON for 60 minutes and let the battery discharge through the bulb,

Then transfer the given toggle switch to the charging mode, verify the meter reading,

The meter need to suggest the charging current of the battery.

The digital meter reading should certainly slowly die down to nil after a period of time, making sure that the battery is entirely charged and geared toward the subsequent action.