Showing posts with label Rectifier. Show all posts
Showing posts with label Rectifier. Show all posts

Wednesday, October 29, 2014

Automobile White crystal rectifier lightweight Circuit Diagram

Without any dedicated buck converter/white crystal rectifier driver IC, youll safely drive several customary Hi-efficient white crystal rectifier modules victimization the battery power out there in cars. Here may be a safe and easy white crystal rectifier driver designed for 12V cars.


Auto White LED Circuit Schematic

Automobile

In the Automobile White crystal rectifier wiring, fastened transformer IC1 (7805) provides a gentle voltage of 5V across C2. Resistors R1 limits the present flow through the white crystal rectifier D1 (3v6/350mA) with the assistance of semiconductor T1 (and T2), i.e. parts R1, T1 (and T2) offer a relentless current to D1. Use a decent sink for T1. This crystal rectifier unit offers a relentless lightweight output for input voltages starting from eight to eighteen volts!
Read More

Thursday, October 16, 2014

Simple Precision full wave Rectifier Circuit Diagram

The circuit provides accurate full wave rectification. The output impedance is low for both input polarities, and the errors are small at all signal levels. Note that the output will not sink heavy current, except a small amount through the 10K resistors. Therefore, the load applied should be referenced to ground or a negative voltage. Reversal of all diode polarities will reverse the polarity of the output

Since the outputs of the amplifiers must slew through two diode drops when the input polarity changes, 741 type devices give 5% distortion at about 300 Hz.


Precision full wave Rectifier Circuit Diagram

Read More

Friday, September 26, 2014

Precision Rectifier Circuit

This precision rectifier operates from an asymmetrical supply, handles input signals up to 3 Vpp and has a frequency range that extends from DC to about 2 kHz. Its amplification is unity, and depends mainly on the ratio R4/R3. Opamp A1 is connected as a voltage amplifier (Ao=l), Az as an inverting amplifier (Ao:-l). Opamp Az, transistor T1 and diode D2 ensure that the output voltage, U2, is identical to the positive excursions of the input voltage, U1. When U1 is positive, the out- put of A1 is held low at about 0.25 V, so that T2 is disabled and can not affect the rectified out- put signal. Components R2 and D1 protect the pnp input stage in Az against negative voltages, which are effectively limited to -0.6 V.

For negative excursions of the input signal, the function of A1, T2 and Dz is similar to the previously mentioned components. The peak output voltage . of the rectifier circuit is deter- ; mined mainly by the maximum output swing of the opamps and the voltage drop across the transistors plus D2: this amounts to about 3 V in all. When the circuit is not driven, it l consumes about lmA, and is therefore eminently suitable for building into portable, battery- operated equipment.


Read More